On August 22, 2008 I changed from rubber bands as the means of holding the Fuel Tank, Receiver & etc. to Velcro on the fuel tank & wire ties on all other components. Following are pictures of these changes
Click on photo to enlarge, click again for full screen
Velcro riveted to fuel tank bracket
Receiver held in place with wire ties.
C & H Ignition Electronics held in place with wire ties.
C & H Electronics & battery covered with thin masonite.
Finished Installation.
24 Oz. fuel tank held in place with Velcro.
Receiver battery & servo reverser.
C & H Electronics covered with Oatey heat protector.
Fuel tank, receiver & battery covered with Oatey heat protector.
 "1 Velcro riveted to fuel tank bracket")
 "3 Receiver held in place with wire ties")
 "5 C & H Ignition Electronics held in place with wire ties")
 "7 C & H Electronics & battery covered with thin masonite")
 "9 Finished installation")
 "2 24 Oz. fuel tank held in place with Velcro")
 "4 Receiver battery & ERD-106 servo reverser")
 "6 C & H Electronics covered with Oatey heat protector")
 "8 Fuel tank, receiver & battery covered with Oatey heat protector")
 "10 Tuned pipe from the rear")
